The Microbeast is a 3-axis electronic stability augmentation system designed and produced in Germany by Beastx which is a division of Freakware (and distributed in the U.S. I used the included double-sided foam tape to affix it, after cleaning both mounting surfaces adequately with rubbing alcohol. Rather than mount the Microbeast up on the X5s gyro platform, I chose to attach it to the side of the frames, next to the receiver to keep the wiring runs short. Yap shaved 2.5 ounces with the conversion The Gaui flybarless head is cleanly designed and significantly lighter than the stock unit with flybar. The weight of the new parts, including the Microbeast was 5.0 ounces, for a nice weight savings of 2.5 ounces. Total weight of parts removed, including the original tail gyro was 7.5 ounces.
#Best rc helicopter simulator for my spectrum install#
Converting over the X5 was easy, taking less than an hour to remove the flybarred rotor head and install the flybarless components. Empire RC was nice enough to provide a flybarless conversion for this helicopter, which consists of a new rotor head block and swash follower, control arms for the main blade grips, a shorter main shaft, and some hardware. I chose to test out the Microbeast on my Gaui X5 helicopter, which I reviewed in flybarred form in a past issue of Heli Pilot. Seen here on Gauis X5, Tony Yap placed it near the receiver to allow short extensions and minimize the wiring clutter. The Microbeast can be installed vertically or horizontally as long as the conenctor block faces forward or backward on the heli. The only requirement is that the connector side of the unit must face towards the front or the back of the helicopter. In terms of mounting, the Microbeast can be mounted in almost any orientation. This can be important in smaller setups, where space can be at a premium. Of course, it can be hooked up via multiple wires to any standard receiver, but it can also be configured to work with a single Spektrum satellite receiver or Futabas S-BUS, forgoing a lot of extra wiring and weight. The Microbeast is very flexible in terms of the types of receivers it can interface with. The overall fit and finish of the case is top notch and screams quality. The aluminum case adds some extra mass to the unit, enhancing its ability to work optimally in vibration-prone environments. The base of the case is constructed out of machined aluminum, while the top is plastic. The Microbeast itself is a single unit, about the size of a small 7- or 8-channel receiver. At about $200, the Microbeast is a bargain, costing about as much as a high end tail gyro, but with much more functionality and capability. The Microbeast, manufactured by BeastX in Germany, is a 3-axis gyro system, utilizing MEMS technology that allows RC helicopters to enjoy fully stabilized flybarless flight. In the past, flybarless controller choices were very limited and costly, but technology has advanced bringing prices down and features up. Unless youve been living under a rock, you know that flybarless helicopters using 3-axis stabilization have exploded in popularity.
0 kommentar(er)
